Cities, towns, boroughs and regional municipalities, from a few hundred luminaires to a metropolitan network
Public works teams run an aging network on a fixed budget, with rising energy costs and little field visibility, so every complaint turns into a truck roll.
I have to modernise my infrastructure without increasing my budget.
Poles, fixtures and cabinets are past their service life, energy costs keep climbing and the capital envelope does not move.
Nobody can say how many fixtures are installed, at what wattage, on which circuit. A conversion starts with a count that does not exist.
A complaint comes in, a crew drives out, and half the time the lamp is working. Without field data the crew leaves blind and the political pressure stays.
Dimming profile, tonight
Open alarms
| Node | Issue | Age |
|---|---|---|
| RME-04812 | Lamp failure | 14 min |
| RME-01197 | Power fault | 1 h 20 |
| RTM-00934 | No response | 3 h 05 |
Centralized control typically cuts total lighting operating costs — energy, maintenance and truck rolls combined — by up to 50%. Montréal published a target of 35% lower energy costs and 55% lower maintenance costs after connecting 132,500 streetlights to one platform.
The same Dimonoff | SCMS deployment that runs your lighting network also manages parking availability, air quality and gas sensors, acoustic event detection, waste collection and sewer or river level monitoring — from the same map interface, with no separate system to buy or learn.
Mississauga: 50,000 streetlights since 2012
Mississauga converted 50,000 streetlights to LED with a utility-accepted meter in every node and cut energy costs 55% against its 2011 baseline. The system has been operated and supported since 2012.
Mississauga converted 50,000 street lights to LED and put a utility-accepted revenue meter inside every node, so adaptive dimming could be billed on measured consumption.
Read the case studyPurchasing can run through Sourcewell contract #041525-DIMN, a pre-awarded cooperative contract open to U.S. public agencies. See how it works
In most cases, yes. The RME controller mounts on a NEMA ANSI C136.41 socket or a four-pin Zhaga Book 18 receptacle and works with any LED luminaire from any manufacturer. Fixtures without a socket use the internal RTM module. One product code covers 110 to 480 Vac (-13% / +6%), 0-10V and DALI.
Most projects combine grants with measured energy savings. Dimonoff prepares the documentation required by the FCM Green Municipal Fund, provincial programs in Quebec, Ontario and Alberta, IIJA, NYSERDA and DOE Better Buildings. Purchasing can also run through Sourcewell contract #041525-DIMN.
The node raises an automatic alarm on a failed lamp, a power fault or a loss of connectivity. The alarm creates a work order directly in Oracle EAM or any CMMS through the REST API, so the crew leaves with the pole, the fault and the address already recorded.
We will tell you what your fixtures, sockets and voltages already support, and what a three-month pilot on 100 to 500 luminaires would cover.
Ask me anything about Dimonoff: specifications, FAQ, products, deployments. I only answer from what's already published on this site.
For a quote, a technical review, or anything I can't find published, the Dimonoff team takes over.
Common questions
Thinking…
I'm having trouble answering right now. Try again in a moment, or contact Dimonoff directly.
Your questions are sent to a third-party AI service to generate an answer grounded in this site's published content, and are recorded, along with this assistant's answers, to help us improve this site.